Hi,
I'm new it STM32 world and I need some help.
I'm working with a dspic30F6014A and I want connect it with a zigbee module provided by DIZIC, specifically DZ-ZB-G model. It contains a STM32W108 chip.
I want connect it through UART pins. An engineer told me if I connect only by these pins (TX and RX) and GND and could program it. Is it truth?
How I can program it? Do I have to connect more than these three pins (like nBOOTMODE, nRESET,...)?
Where I can find some tutorial to start to program it?
I also have an evalutaion kit, from DIZIC too. I've tested it by their software and it works correct. But now, I'm interesting in to program the zigbee module (not the evaluation kit but Dz-ZB module).
Thanks,
Last edited by hibiscusblau (2013-02-28 10:20:59)
