STM CircleOS forum / Best Tools to Start use the STM32F103

Beginnerzero · 2012-08-12 22:02:01

Hi all!

I am retired and a couple of years ago I decided to learn MCUs. I started with the AVR Family, I am able to program in assembly and I know how to use all peripherals like, timers, UARTS, ADC, WDT, SPI, I2C, all type of interrupts, etc.

I have done also some programing using C, but I decided to move up to a 32 bits MCU and I would like to know the best tools to start with like C compiler and debugger IDE (free). Tools to program the MCU or if possible embedded debug tools.

I was thinking on buy a Maple mini that uses a STM32F103CBT6 and is a low cost board, but, I would like to have your suggestions for the development tools as well as the hardware to start with.

Thanks in advance.

Regards,
Manuel

peeyush · 2012-08-13 15:18:43

hi
Beginnerzero,
you can use https://www.keil.com/demo/eval/arm.htm

Beginnerzero · 2012-08-15 19:11:13

Peeyush,

Thanks for the information.

yrt · 2012-08-28 09:23:05

Hi Manuel,

An Open4 with a STM32F103xE or STM32F103xG target board is a powerful low cost solution with embedded debug tools.
You can find on this web site all needed information and examples.
You can download the RIDE framework (GCC compiler + IDE) on Raisonance website.

Regards

# 1 2012-08-12 22:02:01 Best Tools to Start use the STM32F103

Best Tools to Start use the STM32F103

# 2 2012-08-13 15:18:43 Best Tools to Start use the STM32F103

Re: Best Tools to Start use the STM32F103

# 3 2012-08-15 19:11:13 Best Tools to Start use the STM32F103

Re: Best Tools to Start use the STM32F103

# 4 2012-08-28 09:23:05 Best Tools to Start use the STM32F103

Re: Best Tools to Start use the STM32F103

Board footer