STM CircleOS forum / Help needed to configure STM32 F4 canbus @ 1Mbps bit rate

cemt · 2012-06-05 03:04:24

Hi,

I am wondering if anyone has a sample code to configure Stm32f4 micro canbus to run @ 1 Mbips. The can clock peripheral APB1 itself is set to 42Mhz. I am basically after the value(s) that I should put in the CAN_BTR (bit timing register).

Thanks

cemt · 2012-06-14 05:31:14

It has been resolved, no need to answer..

# 1 2012-06-05 03:04:24 Help needed to configure STM32 F4 canbus @ 1Mbps bit rate

Help needed to configure STM32 F4 canbus @ 1Mbps bit rate

# 2 2012-06-14 05:31:14 Help needed to configure STM32 F4 canbus @ 1Mbps bit rate

Re: Help needed to configure STM32 F4 canbus @ 1Mbps bit rate

Board footer