STM CircleOS forum / Error 103 when trying to install new application

ac · 2007-10-10 22:36:51

I am trying to install the Breakout application available in the download section.

I connected the USB to my PC and the mini USB to the stm32 primer.

When I click on the "add_to_Circle.bat" file, I get the following error message:

$1
Any suggestions?

Thanks

Francis · 2007-10-11 08:20:27

This is a strange error...

Did the primer work fine when you received it?
For sure, the problem is "new" because the original programming/test cannot be done at the factory with such an error.
The embedded RLink (ST72651) measures the voltage (port PF.2) of the target Vdd. This voltage is divided by resistors ( R17-R18). It could be that R17 is not properly soldered (or the pin PF2 (54) of the ST7651.
The schematic are available in the "resources" of this web site.

ac · 2007-10-11 20:20:52

The primer is working fine. I am able to play maze and Breakout which were already installed from before.

I also checked the connection between R17 and pin 54 and they are connected.

I did this quick test. I removed the STM32Primer from the other side of the USB cable and clicked on the bat file and it gave me the same error message!

Where can I find the proper drivers?

Last edited by ac (2007-10-12 14:41:38)

# 1 2007-10-10 22:36:51 Error 103 when trying to install new application

Error 103 when trying to install new application

# 2 2007-10-11 08:20:27 Error 103 when trying to install new application

Re: Error 103 when trying to install new application

# 3 2007-10-11 20:20:52 Error 103 when trying to install new application

Re: Error 103 when trying to install new application

Board footer