STM CircleOS forum / Regarding the Primer 2 Extension card

jreveane · 2010-10-14 21:04:29

Hi,

May be an obvious question, but I'd like to use a Primer 2 extension board
to get access to the ADC2 pins but I can't figure out what is the proper
sense to plug the board into the device.
The board is symetric, no hole or pin to prevent the user to make
a mistake.
The only difference between the two faces is there are the Pins names
on one side of the board.
Any advise ?
Thanks.

/joseph

yrt · 2010-10-15 15:34:13

Hi Joseph,

Plug it with the Pins name on the upper side.

Yves

jreveane · 2010-10-15 18:54:06

Thanks Yves. This is what I was suspecting also, but I wanted to double check.
/joseph

# 1 2010-10-14 21:04:29 Regarding the Primer 2 Extension card

Regarding the Primer 2 Extension card

# 2 2010-10-15 15:34:13 Regarding the Primer 2 Extension card

Re: Regarding the Primer 2 Extension card

# 3 2010-10-15 18:54:06 Regarding the Primer 2 Extension card

Re: Regarding the Primer 2 Extension card

Board footer