STM CircleOS forum / MEMS on on STM32-PRIMER

ZHA · 2008-01-29 06:39:04

Hi,
I would to know how to check the output signal of MEMS on STM32-PRIMER by using PC.
Rgds

Francis · 2008-01-29 07:55:01

The best would be to use the USB port. This application would be useful but it is still missing...
At the moment, the best application to visualize the MEMS information is "FastCHART 1.3" (see the project list), but it does not upload the information on the PC.

TroyC3 · 2008-01-29 16:34:44

Perhaps use the virtual com port project to get PC connectivity then using these apps from P&E micro to visualize the data. It comes with the new Freescale Flexis microcontroller Kit but can be downloaded here
[url= http://www.pemicro.com/fixedlinks/demoqetoolkit.cfm#3[/url]Download DEMOQE tool kit, the zip file will contain docs on how to format the data, it also includes the firmware used on the Flexis microcontrollers, so you can also use that.

Troy

# 1 2008-01-29 06:39:04 MEMS on on STM32-PRIMER

MEMS on on STM32-PRIMER

# 2 2008-01-29 07:55:01 MEMS on on STM32-PRIMER

Re: MEMS on on STM32-PRIMER

# 3 2008-01-29 16:34:44 MEMS on on STM32-PRIMER

Re: MEMS on on STM32-PRIMER

Board footer