phpMyVisites | Open source web analytics
Pages: 1
Hi,I'm new member of this site. I'm not able to establish debug session with rlink from primer board. I got errors and warnings like below.Any suggestions are kindly welcome.
G:\arm\openocd\src>openocd -f ..\tcl\interface\rlink.cfg -f ..\tcl\target\stm32. cfg Open On-Chip Debugger 0.4.0 (2010-07-28-23:12) Licensed under GNU GPL v2 For bug reports, read http://openocd.berlios.de/doc/doxygen/bugs.html 1000 kHz jtag_nsrst_delay: 100 jtag_ntrst_delay: 100 Info : clock speed 375 kHz Info : JTAG tap: stm32.cpu tap/device found: 0x3ba00477 (mfg: 0x23b, part: 0xba0 0, ver: 0x3) Info : JTAG tap: stm32.bs tap/device found: 0x16410041 (mfg: 0x020, part: 0x6410 , ver: 0x1) Error: JTAG-DP OVERRUN - check clock, memaccess, or reduce jtag speed Error: MEM_AP_CSW 0x23000052, MEM_AP_TAR 0xe0001004 Error: JTAG-DP OVERRUN - check clock, memaccess, or reduce jtag speed Error: MEM_AP_CSW 0x23000052, MEM_AP_TAR 0xe0001004 Warn : Block read error address 0xe0001000, count 0x1 Info : stm32.cpu: hardware has 6 breakpoints, 0 watchpoints Error: JTAG-DP OVERRUN - check clock, memaccess, or reduce jtag speed Error: MEM_AP_CSW 0x23000042, MEM_AP_TAR 0xe000edf0 Error: JTAG-DP OVERRUN - check clock, memaccess, or reduce jtag speed Error: MEM_AP_CSW 0x23000042, MEM_AP_TAR 0xe000edf0 Error: JTAG-DP OVERRUN - check clock, memaccess, or reduce jtag speed Error: MEM_AP_CSW 0x23000042, MEM_AP_TAR 0xe000edf0 Error: JTAG-DP OVERRUN - check clock, memaccess, or reduce jtag speed
Last edited by viki (2010-07-30 07:19:05)
Offline
I had the same problem. Try disabling polling:- run openocd normally with the same command options you used in your post above- ignore errors messages and open another console and do:telnet localhost 4444- at the prompt digit:>poll offThis should stop the error messages. I've not tried yet to program the flash, but checking it with:>halt; flash info 0worked :-)Hope this helps, best regards.
