Just loaded a new revision of my code to the Primer 2 target, the screen flickered when it ran and then every thing when dead (only red LED on when plugged in to USB DEBUG).
When trying to re-program the target (post failure) I get the OPI Dialog error 'Target Power Failure: Measured 1.5V' and on other occasions 'Target Power Failure: Measured 0.8V', and sometimes 'Target Power Failure: Measured 0.9V'.
I am using this device for my final year uni project, hence any help resolving this issue would be very gratefully appreciated.
Regards,
Paul
UPDATE: 18:11 05/12/09
Ok, so upon further investigation U9 is very hot!, can someone please advise what the procedure for resolving this design fault is? i.e. whether I have to source the regulator myself, or if RAISONANCE supply them, or a repair procedure FOC?
Last edited by paulh100 (2009-12-05 18:13:51)
