Hello,
It seems the default Interface of Primer 2 is:
Main Menu-> Config -> Interface -> Loudspeaker : yes
Main Menu-> Config -> Interface -> User Input -> MEMS
I prefer to have
Main Menu-> Config -> Interface -> Loudspeaker : no
Main Menu-> Config -> Interface -> User Input -> Both (M+J)
Sometimes my soft hangs in such a way that I need to disconnect/reconnect the battery of the Primer. Then I change the Config to my preference.
When using Ride Debug with the Primer, the config seems to be reset to the default, I keep changing it before selecting my App, but at the next reprogramming of the Flash, the default comes back.
And then at some point, the primer remembers my config instead of using the default, even if the flash is reprogrammed by Ride Debug.
Until I need to disconnect/reconnect the battery, etc.
There is surely a deterministic reason why my config settings are finaly not overwritten by the default during the load of the debug code by Ride, but I didn't identify it.
Do you know what I should do to save my config so that it isn't reset the next time I use Ride to debug ?
Thanks for your help,
Jerome