STM CircleOS forum / preventing from rewriting when debug

tojapan · 2007-12-05 05:23:07

Ride7 seems to rewrite code in the flash whenever it enter debug mode.
How can I run into just debug mode without any writing?

Last edited by tojapan (2007-12-05 05:25:09)

Francis · 2007-12-05 07:52:59

At the moment, this is not possible. The debugger willl perform a "mass-erase" of the FLASH then will program the whole application (and a few "reset" are perfomed too).
To be done in the future....

# 1 2007-12-05 05:23:07 preventing from rewriting when debug

preventing from rewriting when debug

# 2 2007-12-05 07:52:59 preventing from rewriting when debug

Re: preventing from rewriting when debug

Board footer