/var/www/restricted/ssh/stm32/www/stm32circle/ STM CircleOS forum / MEMs (0,0,0)

Username:     
Password:     
             

Forum

# 1   2007-08-21 14:46:52 MEMs (0,0,0)

GJ
New member
Registered: 2007-08-16
Posts: 1

MEMs (0,0,0)

Hi there, would it be possible in CircleOs to enable the user to select the starting position. For example, by positioning the device where the user wishes the device to accept as zero and pressing the button to allocate this offset. For some of the applications it would be better, as it would be possible to lay the device on a flat surface and set this as zero movement if preferred. Thanks GJ

Offline

 

# 2   2007-08-22 10:01:02 MEMs (0,0,0)

Francis
Administrator
From: France-Grenoble
Registered: 2007-07-09
Posts: 890

Re: MEMs (0,0,0)

There is a function available in the API: see  "MEMS_SetNeutral()"

http://www.stm32circle.com/circleos_doc … 0add6e0ee0

Offline

 

Board footer