STM CircleOS forum / can't debug standalone toggle application

denis · 2007-10-27 21:57:37

I opened the included stand alone toggle application with the Ride7 IDE and tried to compile and then debug it using "Debug" > "Start". The compile went fine, but debug failed. The message in the "Debug Output" panel is
"Unable to connect to the target"

However, when I attempt to debug I see the green led on the bottom left side of the board flash - as if the software is communicating with the embedded rlink.

If I use "Options" > "Project Properties" > "Cortex RLink" > "Advanced Options" "Erase target now!" and "Write target FLASH now!" then the toggle program does load and run.

Anyone have any ideas on why that works, but "Debug" > "Start" does not?

lionel · 2007-10-30 09:35:31

Hello Denis,

it works for me. Did you download and install the lastest CD-ROM image ?

Lionel

denis · 2007-11-04 00:44:25

I uninstalled the previous version downloaded and installed the latest CD-ROM image, but still have the same problem.

Francis · 2007-11-05 08:52:05

Is the RLink driver properly installed? (There are sometimes some problems when installing RLink. See: http://www.stm32circle.com/forum/viewto … d=207#p207 ).

# 1 2007-10-27 21:57:37 can't debug standalone toggle application

can't debug standalone toggle application

# 2 2007-10-30 09:35:31 can't debug standalone toggle application

Re: can't debug standalone toggle application

# 3 2007-11-04 00:44:25 can't debug standalone toggle application

Re: can't debug standalone toggle application

# 4 2007-11-05 08:52:05 can't debug standalone toggle application

Re: can't debug standalone toggle application

Board footer