STM CircleOS forum / Primer2 Expansion Board, Mechanical Dimensions

yewie56 · 2009-01-23 11:43:43

Is there any mechanical specification for the Primer2 Expansion Board and the mechanical description of the Primer2 Expansion connector (eg pin-pitch dimension) ?

Francis · 2009-01-23 12:40:11

Here it is:
ftp://www.raisonance.com/pub/forum/stm32circle/Primer2-Extension-Mechanical.jpg
The link has been added into the resources section too.

samarkh · 2009-01-23 13:29:33

Do you have a part no for the edge connector as well please?

Yours Simon M

Francis · 2009-01-23 17:07:53

It's a simple 20 contact female connector (HE10-HE14 like). .
Possible references:
Harwin M20-7831046 - Farnell : 799-2025
Etec : 549-4949
Kontec : 230-4916
Check the height in the datasheet before ordering. The plastic header should be 8mm (or 8.5) height.

# 1 2009-01-23 11:43:43 Primer2 Expansion Board, Mechanical Dimensions

Primer2 Expansion Board, Mechanical Dimensions

# 2 2009-01-23 12:40:11 Primer2 Expansion Board, Mechanical Dimensions

Re: Primer2 Expansion Board, Mechanical Dimensions

# 3 2009-01-23 13:29:33 Primer2 Expansion Board, Mechanical Dimensions

Re: Primer2 Expansion Board, Mechanical Dimensions

# 4 2009-01-23 17:07:53 Primer2 Expansion Board, Mechanical Dimensions

Re: Primer2 Expansion Board, Mechanical Dimensions

Board footer