|
|
|
|
Inertial Center for Primer2 1.0.1
|
|
 |
|
Simple service application for Inertial Moving System optimized for Primer2 |
| Code size: | 8 KB |
Author: | nemymila |
| Source files included: | yes |
Version: | 1.0.1 |
| Use circleOS: | yes (4.x) |
Creation date: | 2014-04-11 14:32:17 |
| Hardware modification: | yes |
Modification date: | 2014-04-11 14:37:48 |
| Based on the STM32 Primer: | Primer2 |
| |
| |
|
| Downloads: | 2368 |
Views: | 33021 |
| |
|
| Vote: |
|
Average ratings: | 0/5 (0 rates) |
Download:
Inertial-Center-for-Primer-2-1.0.1.zip (740 KB) 
Description:INERTIAL CENTER v1.0.1 for PRIMER2
Example project using the Inertial Extension card with ST sensors:
magnetometer / accelerometer : ref LSM303DLM,
gyroscope : ref L3G4200D,
pressure / temperature : LPS001D.
This is a ready-to-use PRIMER2 extension to the yst's project 'Inertial Center 1.0'.
Few changes were made: (compared to the yst's version)
- GPIO PIN numbers were remapped.
- Coordinates of display messages were changed so that they fit the Primer2 screen dimensions.
- At the beginning of the Application_handler calls of
TIM_Cmd(TIM2, Enable) and Gyro_Init() were added. Otherwise I2C bus hangs in HIGH state,
ie. bus freezes right in the 2nd pass through the Application_handler.
|
|
|
|
|
