STM CircleOS forum / Can't power up

Zari · 2009-10-22 20:08:08

Hi, I'm not very good wih it so I need help.

I debbuged one aplication on my Primer2, and then it shut down.
I can't power it up until now.
It was a brand new Primer. I uses it for the firs time yesterday.
Haw can I solve it?

yrt · 2009-10-23 06:19:42

Is the Primer really shutdown, is the screen stalled white or black ?
Did it shutdown when the application was running ?

The first thing to do is to try to reload the factory binary.
Download the "Primer2_Upgrade v3.8.zip" in resources pages, then launch the "Restore_Primer2_Circle_Factory.bat" when maintening the Primer button pushed.

If the check fails, verify the power supply voltages, and take a look at the "Resources/Resolve Known Problems" section.

Zari · 2009-10-23 06:29:49

After pushing the orange button screen flashes white, and the red LED light is merely noticeable. PC is unable to connect via USB with a Primer2.Debugging's also unavailable.

It shutdown just after debugging (external application (program from your page)

The Restore_Primer2_Circle_Factory.bat (and others) outputs as follows:

!!! WARNING: This will program the original code into the STM32-Primer2. !!!
!!! All applications currently loaded will be erased. !!!

Press Ctrl-C to abort.
Press any key to continue...

Cortex_pgm: software for programming Cortex chips using a RLink as master.
Copyright Raisonance 2007.

(0)
Selecting target: STM32F103VET6...
(0)
Connecting to RLink...
!!! Error 304: Unable to open USB communication with RLink.
Please check that the dongle is connected and that the driver is correctly loaded.

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! ERROR !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

STM32-Primer2 programmation failed. Please check that the "Debug" USB connector
is plugged and that the STM32-Primer2 is powered up.
(press the STM32-Primer2 button if you are unsure)

Press any key to continue...

Last edited by Zari (2009-10-23 06:36:42)

yrt · 2009-10-23 07:12:30

Are you sure you are connected to the "DEBUG" USB port of the Primer2, because the message you got is this one we get when we are connected to the STM32 USB connector ?

Zari · 2009-10-23 07:16:13

Yes i'm sure.
I tried on both ports.
I was searching for an answer on forum but only solution to it was to debug something, but to debug my primer must be powered on, but it is impossible in my case.

ah · 2009-10-24 08:57:27

Hello, I am facing the same problem, the only way I can program the device is by pressing the oragne switch during the download?

# 1 2009-10-22 20:08:08 Can't power up

Can't power up

# 2 2009-10-23 06:19:42 Can't power up

Re: Can't power up

# 3 2009-10-23 06:29:49 Can't power up

Re: Can't power up

# 4 2009-10-23 07:12:30 Can't power up

Re: Can't power up

# 5 2009-10-23 07:16:13 Can't power up

Re: Can't power up

# 6 2009-10-24 08:57:27 Can't power up

Re: Can't power up

Board footer