Hi Steeve,
you have done a good job with Fast-Chart!!
What is impressing is the fact that the noise is very low!! What kid of filtering have you used??
I loaded the application "Mems" but when it shows the value of X,Y,Z there is a lot of noise: with the object steady on the desk the X values can vary from -259, 10, 259. Probably there is a bug!!
I was planning to use STM32 Circle on an helicopter as a platform stabilizator using the Mems and as an upgrade I was thinking to add a three axys Gyro.
Tell me something about the management of the noise from the Mems.
Thanks
