STM CircleOS forum / USB to CAN converter Using STM32f103

chowdaiah · 2012-07-23 11:19:17

Hello,

I am working on the STM32F103C8T6 controller for completing a data transfer task. Here on one end, the USB has to be used and on the side, the CAN needs to be used.

However, this transfer has to be done simultaneously on the USB and the CAN. That is these two peripherals must work at the same time.

I would like to know if this can be done using STM32F103 series. If so, Could you point me to any application note on your website, which can illustrate this task.

regards,
chowdaiah

uhululu · 2012-08-31 21:47:55

Hey chowdaiah

If you look on this site,
http://www.stm32circle.com/forum/viewtopic.php?id=404

there is a similar question.

The answer is: you cold NOT USE
both at the same time. Change to the STM32f105/107 or a higher controller (F2/F4...)

But im not really shure that it works with a F1...

-Stefan

# 1 2012-07-23 11:19:17 USB to CAN converter Using STM32f103

USB to CAN converter Using STM32f103

# 2 2012-08-31 21:47:55 USB to CAN converter Using STM32f103

Re: USB to CAN converter Using STM32f103

Board footer