STM CircleOS forum / STM32 PRIMER 2. LEDS AND BUTTONS. WITHOUT CIRCLE OS.

Gediminas · 2012-01-23 18:41:51

Hello, I am modifying Ride 7 ''Toggle" example program which works without circle OS. I want that this program should work like this:
When no buttons pressed: LEDs just blinking.
When button pressed (main or one of joystick): Stop blinking. LEDs are ON.

Now I have a situation then LEDs stops blinking only then main buttton is pressed. When I press joystick button (left for example) - LED's still blinking.

Any suggestions?

Main part of code:

while ( 1 )
{

do
{
bpinput = (( GPIO_ReadInputData( BP_GPIO ) ) & ( BP_PIN ) );
if ( bpinput )
GPIO_Write( LEDS_GPIO, ( 1 & LEDS_BOTH_PINS ) );
}
while ( bpinput );

jstkinput = ( (GPIO_ReadInputData(JSTK_GPIO)) & ( JSTK_ALL_PINS ) );
jstkinput = (( u16 )JSTK_GPIO->IDR ) & ( JSTK_ALL_PINS );

switch ( jstkinput & ( JSTK_ALL_PINS ) )
{
case GPIO_Pin_3:
GPIO_Write( LEDS_GPIO, ( 1 & LEDS_BOTH_PINS ) );
break;

case GPIO_Pin_4:
GPIO_Write( LEDS_GPIO, ( 1 & LEDS_BOTH_PINS ) );
break;

case GPIO_Pin_5:
GPIO_Write( LEDS_GPIO, ( 1 & LEDS_BOTH_PINS ) );
break;

case GPIO_Pin_6:
GPIO_Write( LEDS_GPIO, ( 1 & LEDS_BOTH_PINS ) );
break;

default :
//no buttons are pressed
//just go on toggling
break;
}

// Toggle LEDs
GPIO_Write( LEDS_GPIO, ( toggle & LEDS_BOTH_PINS ) );

// increment Toggle variable
toggle++;

// Insert delay
Delay( delayvar );

}
}

yrt · 2012-01-25 07:13:57

The instruction :
// Toggle LEDs
GPIO_Write( LEDS_GPIO, ( toggle & LEDS_BOTH_PINS ) );

is always called, whatever the joystick is pushed or not.
It should be better to move this code in the default section of your switch.

# 1 2012-01-23 18:41:51 STM32 PRIMER 2. LEDS AND BUTTONS. WITHOUT CIRCLE OS.

STM32 PRIMER 2. LEDS AND BUTTONS. WITHOUT CIRCLE OS.

# 2 2012-01-25 07:13:57 STM32 PRIMER 2. LEDS AND BUTTONS. WITHOUT CIRCLE OS.

Re: STM32 PRIMER 2. LEDS AND BUTTONS. WITHOUT CIRCLE OS.

Board footer