STM CircleOS forum / primer broke?

romanv · 2011-01-17 21:42:59

Dear forum members,

I have primer2 and the other day I loaded a test project in it and that was the end. Now when
i try to do it again, I get a message power failure:measured 2.000v or 1.9v. The very last message was Error 203: Wrong MCU device ID 0x10016414. What is going on with my primer2? Did it break?

Thank you for any help.

yrt · 2011-01-18 07:18:37

The message is strange, because the MCU ID is correct.
It is possible that your Primer is broken.
Take a look at this page :
http://www.stm32circle.com/resources/known.php#reg_fail

# 1 2011-01-17 21:42:59 primer broke?

primer broke?

# 2 2011-01-18 07:18:37 primer broke?

Re: primer broke?

Board footer